DIY Earring Holder from Reclaimed Wood – Quick Guide

Tired of tangled earrings and flimsy holders that break? Build a sturdy DIY earring holder from reclaimed wood in under an hour—no fancy tools required.
This simple project transforms scrap wood into a functional, stylish rack that keeps every pair visible and secure.

DIY Earring Holder from Reclaimed Wood: Step‑by‑Step Build

Follow these six easy steps to turn any reclaimed board into a custom earring holder.

Choose a piece of reclaimed wood about 12 inches long and 6 inches wide—an old pallet board, coffee‑table off‑cut, or fence slat works perfectly.

If the board exceeds your desired length, measure twice and cut once with a handsaw, then sand the fresh edges immediately to avoid splinters.

Start with medium‑grit sandpaper, sand with the grain, then finish with fine‑grit for a smooth touch that lets hooks sit flush and prevents snagged earrings.

Pre‑drill holes spaced roughly one inch apart using a tiny drill bit, then screw in quarter‑inch eye‑hooks by hand—or tap them in with a nail and hammer if you lack a drill.

Wipe the board with a damp cloth, let dry, then optionally apply chalk paint, a light stain, or clear polyurethane for color and protection.

Secure the holder to the wall with two small picture‑hook nails, or simply lean it against a bookshelf; add a felt pad to the back if leaning to protect surfaces.

Space the hooks so larger hoops don’t clash with smaller studs, label hooks with tiny tags for quick visual cues, and enjoy a tidy dresser every morning.

Seeing your earrings neatly hanging makes the effort worthwhile, and the whole project stays under $10, proving that beautiful storage doesn’t have to break the bank.