How to Hide TV Wires Behind Drywall: Easy Guide

Tired of tangled cords ruining your sleek TV mount? Learn how to hide tv wires behind drywall in just a few steps—no electrician needed. This guide gives you a clean, professional look while keeping everything safe and up to code.

How to Hide TV Wires Behind Drywall: Step‑by‑Step Process

Plan the route – Sketch where the TV sits, locate the nearest outlet, and mark two access points: one 2‑3 inches above the mount for HDMI/audio cables and another at outlet height for the power cord.

Locate the studs – Run a stud finder horizontally across the wall; mark the edges of each stud so you avoid cutting into them.

Cut the access holes – Using a drywall or keyhole saw, make a 2‑inch hole at each marked spot. Keep the openings just large enough for the cables to pass through.

Drop a simple fish tape – Push a piece of fish tape (or a straightened coat hanger) up from the lower hole toward the upper hole. When the tip emerges, attach your HDMI and speaker cables to the tape and pull them up through the wall cavity.

Run the power safely – Feed a thin‑wall, in‑wall‑rated power cord the same way, but keep it on its own side of the wall. If you’re unsure, install a drywall cable plate (mud ring) at the top hole to separate low‑voltage and high‑voltage lines, satisfying code requirements.

Secure the cables – Pull the cables through until there’s a slight slack, then snap the drywall cable plate into place. It sits flush with the wall and holds both power and signal lines neatly.

Mount the TV – Re‑attach the TV to its bracket, ensuring the cables slide through the plate without tension. Tighten the screws and step back to admire the clean line.

Finish with a faceplate – Install a low‑profile wall plate where the cables exit the wall. This hides the holes and gives a showroom‑ready finish.

That’s the complete how to hide tv wires behind drywall workflow: simple tools, minimal cutting, and a safe, code‑compliant result. Follow these steps, adjust hole locations to your layout, and enjoy a cord‑free wall that looks professionally installed.